Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Importing STEP file error

Status
Not open for further replies.

Poorpaulus

Automotive
Joined
Feb 3, 2002
Messages
89
Location
GB
Right then. I have imported a stamped metal surface STEP file. In the feature manager there is a little error logo on the Surface-import step telling me that it is not happy. As a result, I can't do anything modifications other than delete a few of the surfaces. When I try anything else, I keep getting:

Surface-Imported1: Warning: Imported geometry has 3 Check entity error(s)

Is there something that I can do differently so that there are no errors because I can't find the errors.

Paul.
 
Paul,
Right click imported geometry and choose Diagnosis -> Faces -> Diagnose & than you can fix or remove bad faces.
 
Tools\Check will tell you more about the problem or problems too.

Regards,

Scott Baugh, CSWP [borg2]
CSWP.jpg

faq731-376
 
If diagnosis fails to fix the faces, perhaps delete the faces and replace them with surfaces of your own making, then knit the surfaces and make a solid.

I do this sometimes. Usually the offending surfaces are lends (spherical portions are a nuisance). These aren't difficult to replace. Patch works well for this.

[bat]"Great ideas need landing gear as well as wings."--C. D. Jackson [bat]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top