Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Importing volume in Ansys workbench

Thread starter aliesmal110
Start date May 6, 2015

Status: Not open for further replies.

May 6, 2015

aliesmal110

Mechanical

Hi dears
I am working with ANSYS WORKBENCH 16 and my model is a standard bearing but when I import a STEP file to ANSYS the rollers of bearing are presented as surfaces and dont have volume.
I want to know if there is any solution for this problem.
Could I make volume from this surfaces in ANSYS WORKBENCH.
Thanks