Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

In-line pressure balanced expansion joint at Caesar II

Status
Not open for further replies.
Jacks123

Jacks123

Mechanical
Dec 10, 2013
2
Hello!!
I am new at this.. I hope you can give some advice how to model a In-line pressure balance expansion joint without any elbows on Caesar II Software ??.. I am having some issues with results .. not convinced!!
Thanks !!!.. :)
 
Status
Not open for further replies.

Similar threads

TheValveLady
  • Locked
  • Question
Ground union joint
Replies
3
Views
861
SnTMan
SnTMan
david339933
  • Locked
  • Question
Has anyone had experience in Polyph 2
Replies
4
Views
776
EdStainless
EdStainless
anne_pe
  • Question
Incorrect passivation type for 17-4 PH
Replies
12
Views
2K
mfgenggear
mfgenggear
BiPolarMoment
  • Locked
  • Question
Magnetic 316L and galling (investigation)
Replies
7
Views
3K
EdStainless
EdStainless
Salmet
  • Locked
  • Question
Internal Pickling and Passivation of Super duplex stainless steel SA 790 UNS 32750
Replies
3
Views
1K
SJones
SJones

Part and Inventory Search

Sponsor

Back
Top Bottom