Incomplete output job aborted

[abc123ali]

Respected ABAQUS users, I am doing a shear testing of the model attached here for which the force-displacement response at the reference point in y-dimentions: RF2 U2 are just upto 0.045 sec while the simulation doesnt go beyond to show complete cyclic response even after the time increment to very less value. The cae file is attached here having job name "400laminnobend". Kindly assit.

Thanks for cooperation

 

[FEA way]

The analysis struggles to converge but eventually completes when I run it in Abaqus 2024. If it doesn’t converge in your case (and thus you have the results only up to the last converged increment) then you should take a close look at those results and check all warning messages. There might be issues with material behavior entering perfect plasticity or some instabilities.