incorect display of surfaces in NX7

[eex23]

Hi,

are there any settings in NX7 or problem is somethere else?
I am using latest drivers for my video card (ati fire gl5600, workstation hp hw4600).

nx7.0.1.7 mp2
winxp 32bit +sp3
512mb video ram
2gb system ram

 

[eex23]

forgot to mention, that i have both nx4 and and nx7 installed on my pc. nx4 works fine this this. smth wrong only with nx7.

 

[cowski]

The latest drivers are not necessarily the best for NX. Check the GTAC site for certified drivers for your particular graphics card.

 

[JohnRBaker]

Go to...

Preferences -> Visualization Performance -> General Graphics

...and check in the 'Session Settings' section of the dialog to see that 'Backface Culling' is NOT toggled ON. If it is, toggle it OFF.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[eex23]

Thanks John for advice, it helped.