uGlay
Mechanical
- Jan 6, 2006
- 389
Imagine a 4" dia. x .100" thickness part "part1". Now this part has a ring around it over-molded "part 2". "part 1" has a 1" hole right on the center.
I want to indicate on the print that the ID of "part 1" must be within .010" tol. from the i.d. of "part 2"
I added a datum callout on the i.d. of "part 2"
am i on the right path? I am redoing this print and the way it is called out now is with a long paragraph and leaders pointing at the edges of the parts that are supposed to be concentric.
I want to indicate on the print that the ID of "part 1" must be within .010" tol. from the i.d. of "part 2"
I added a datum callout on the i.d. of "part 2"
am i on the right path? I am redoing this print and the way it is called out now is with a long paragraph and leaders pointing at the edges of the parts that are supposed to be concentric.