Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Information on inject molding process
- Thread starter spech
- Start date
patprimmer
New member
Ummm
Get a job as an operator in an injection moulding shop.
Do a course on injection moulding.
Read the manuals and technical literature for the machines and materials.
Carefully break small hole in one end of egg shell by gently tapping with a needle. Put finger over hole and turn over. Repeat process, but insert needle further to break yolk. Hold egg over mouth and suck through hole.
Regards
eng-tips, by professional engineers for professional engineers
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
Get a job as an operator in an injection moulding shop.
Do a course on injection moulding.
Read the manuals and technical literature for the machines and materials.
Carefully break small hole in one end of egg shell by gently tapping with a needle. Put finger over hole and turn over. Repeat process, but insert needle further to break yolk. Hold egg over mouth and suck through hole.
Regards
eng-tips, by professional engineers for professional engineers
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question