Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Information to be reported in a CMTR

isoca

isoca

Materials
Mar 16, 2008
58
Is it acceptable for ASME III code to complete a CMTR using OK or NOK instead of the numerical value?
For example, in a production of 10,000 tubes, should the actual value of the external diameter of each tube be reported?
 
You must log in or register to reply here.

Similar threads

dcox519
  • Locked
  • Question
A928 (UNS S32750) Pipe to be used on ASME Vessel 2
Replies
13
Views
227
r6155
r6155
Zachary Gagnon
  • Locked
  • Question
Coupling a DN400/PN10 flange to a a B16.5/150 Butterfly valve
Replies
7
Views
127
LittleInch
LittleInch
kremenco
  • Locked
  • Question
Should the Jacket of a Cryogenic Vessel be considered as pressure vessel?
Replies
7
Views
175
LittleInch
LittleInch
Motivated Apprentice
  • Question
Diameter in ASME IX
Replies
2
Views
487
Motivated Apprentice
Motivated Apprentice
Mustufa70
  • Locked
  • Question
Does tracing coil on non-pressure vessel requires to be examined as Per ASME design equiments
Replies
0
Views
58
Mustufa70
Mustufa70

Part and Inventory Search

Sponsor

Back
Top Bottom