Injection moulding question

[Graeme Allison]

Hi,

I am looking at getting the attached part injection moulder, my worry is how the mould is produced with the internal slots, any advice is much appreciated.

Regards
Graeme

 

[MacGyverS2000]

That's the molder's problem, not yours. That statement is only partially tongue-in-cheek.

Speak to a few molding companies... if they believe it will be a difficult/impossible mold, work with them to redesign the part so it can be molded. Material will have a large effect on what can/can't be molded.

Dan - Owner

http://www.Hi-TecDesigns.com