Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inlet piping for factory installation

Status
Not open for further replies.

Jetpower1

Industrial
Jan 28, 2014
1
Afternoon All,

My company has tasked me with organising a very simple inlet piping system.
I believe it falls into CAT D
It is literally 3Bar mains water feed supplying a positive displacement pump.
max flow 13.5 l/min
The system will be a permanent indoor fixture.

my question is can I use PVCu Solvent weld pipe?
It's well within flow, pressure and temp rating.

I only ask in case there is some directive I haven't found that specifies what piping should be used.

Any opinion is welcome.
Thanks in advance.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor