Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Insert dimensions into a drawing

Status
Not open for further replies.

Pachem

Mechanical
May 30, 2002
53
Is it possible to make button "mark dimension to be imported into a drawing" off as default?
 
Replies continue below

Recommended for you

No there is no option anywhere to Turn off this function. Only and RMB uncheck "Mark for Drawings". You might be able to create a Macro that would turn this off for every dimension after the model is completed.

Regards,

Scott Baugh, CSWP [pc2]

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor