Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Insert Parameter into Mechanism Measure

Thread starter seymours2571
Start date Apr 28, 2010

Status: Not open for further replies.

Apr 28, 2010

seymours2571

Mechanical

Hello All,

I have been scratching my head for the last hour trying to figure how on earth to insert a Pro/Engineer parameter into a Mechanism measure?

I am currently using WF4, however I looked around in WF5 and could see anything there either?

Any ideas or workarounds would be greatly appreciated.

Thanks,

Steve

Stephen Seymour, PE
Seymour Engineering & Consulting Group

http://www.seymourecg.com