Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inserting only a few sheets from a larger set of drawings

Thread starter IDabbleInModeling
Start date Jul 17, 2009

Status: Not open for further replies.

Jul 17, 2009

IDabbleInModeling

Military

Hey guys, real quick question.

I have a set of drawings with about 10 sheets in it. I need to insert two drawings from another set of drawings with around 20 sheets in it. Is there a way to do this without having all the models and drawings from the 20 sheet set become associated with my 10 sheet set?

This is probably a trivial question, but I want to be absolutely sure. Some of the models in both sets have the same names, and that's not a mistake I want to make again.

Thanks fellas.