Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inside Welded Corner in Sheet Metal Part

Thread starter cinnamongirl
Start date May 17, 2013

Status: Not open for further replies.

May 17, 2013

cinnamongirl

Mechanical

Is there a way to create an inside welded corner in a sheet metal part? I have a sheet metal part with three sides that share one corner and I'd like place a weld on the inside to close the gap between two edges. The tutorials in SolidWorks show how to place a radiused welded corner but I can't find anything on how to place a filleted corner.