Instance Feature 2

[Finglas]

trying to insert a pattern (instance feature) in NX6 but it won't allow me. Doing it this way: Instance Feature>Rectangular Array>(select features I want to pattern)>Input number along YC and YC offset as it's in Y axis direction)>OK.

Get error message in picture - "Unable to trim - change trim type data". What's the problem?

 

[MickyV007]

This error could be caused if you try to cut your solid in two with the pattern, or if the patern will interact with other features.

Best regards,

Michaël.

NX4+TC9 / NX6+TC8Unified / NX7.5 native

 

[eex23]

If you try to pattern extrude feature, make sure, that extrude has limit "extrude until extended", or greater value than base feature (feature you are substracting from)