Instantiate Macro, KT1, and PKT License

[jzecha]

I am very confused based on my research, so I hope someone can shed some light on this for me.

Do I need a PKT license to run a macro that runs an PowerCopy?

I have read multiple posts that I only need the KT1 License, but I can't seem to get my basic Macro to work.

So maybe I am doing it wrong?
Can someone provide me a very basic PowerCopy Part and Macro that work together that I can look at to see what I am doing wrong?

 

[ferdo]

What do you want to do in fact? Can you give/show an example?

Regards
Fernando

https://www.youtube.com/playlist?list=PL9mSHa4SOedV3dr0D3kfIWFUg7mIYm94k

https://www.youtube.com/playlist?list=PL9mSHa4SOedVUEkEojiX_kdzpe0sDbaz2

 

[jzecha]

I have two reasons for this post.

1st
I have two parts I want to create macros to Instantiate from.

2nd
I want to automate putting in 100+ of the same hole in a bond tool.

I have the vectors and the common loft surface to build the holes off.
I created a PowerCopy that works with one, and i was going to try to setup a Macro that takes that PowerCopy and cycles it through all my vectors.

I do not have the PKT license so I can't create a knowledge pattern.