CChulo
Electrical
- Oct 14, 2005
- 14
Hi:
I am trying to integrate a Keyence SR-610 2D Scanner using a Keyence N-L1 dedicated communication unit to an Allen Bradley L23E CompactLogix via Ethernet. On the AB side I've added a Generic Ethernet Module for comms, the problem here is that I've been looking for days for the correct combination of connection parameters (Input, Output and Configuration in the Module Properties Window). Since the N-L1 is not an Ethernet/IP (I could be wrong) I'm planning to use messaging between the CompactLogix and the N-L1 once I figure out the communication issues.
To set up the N-L1 and SR-610 I've been using Auto-ID Navigator.
Any thoughts will be appreciated.
Thanks,
JDD
I am trying to integrate a Keyence SR-610 2D Scanner using a Keyence N-L1 dedicated communication unit to an Allen Bradley L23E CompactLogix via Ethernet. On the AB side I've added a Generic Ethernet Module for comms, the problem here is that I've been looking for days for the correct combination of connection parameters (Input, Output and Configuration in the Module Properties Window). Since the N-L1 is not an Ethernet/IP (I could be wrong) I'm planning to use messaging between the CompactLogix and the N-L1 once I figure out the communication issues.
To set up the N-L1 and SR-610 I've been using Auto-ID Navigator.
Any thoughts will be appreciated.
Thanks,
JDD