Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Intermediate Wind Girder

Status
Not open for further replies.

napster385

Petroleum
Apr 4, 2013
34
0
0
PH
Hi Everyone,

Is installation of intermediate wind girder on inside of tank permitted by API 650?
 
Replies continue below

Recommended for you

It would normally be avoided due to either having a floating roof, or due to the possibility of having one at some point in the future. But I don't see that API prohibits it, either. The wording on the top wind girders says they shall "preferably" be located outside.
 
If I were to do such a design, I would make sure that the corrosion allowance (if applicable) was applied to all surfaces of the wind girder.
 
It is not prohibited and it is not that uncommon in extremely high snow areas where falling snow and ice can wipe out girders
 
Status
Not open for further replies.
Back
Top