Tofflemire
Marine/Ocean
- Oct 3, 2002
- 312
Hi All,
Recently I saw a post on here about recovering a workspace in Intralink. Well I did the unthinkable and deleted a workspace when I was not paying attention. While I thought about it, I thought I would be able to use the Intralink .proi log file to recover, as you aware that did not work.
What I did next was very interesting, I checked out all my parts that I had done earlier and then started ProE. I than ran the ProE trail file, WOW it started to open parts, drawings and modify them as I did earlier. This worked great until it came to a stop or crash the trail file. I was unable to recover everything but I did get back about 3-4 hours of work.
This may be of use to someone else out there...
Tofflemire
Recently I saw a post on here about recovering a workspace in Intralink. Well I did the unthinkable and deleted a workspace when I was not paying attention. While I thought about it, I thought I would be able to use the Intralink .proi log file to recover, as you aware that did not work.
What I did next was very interesting, I checked out all my parts that I had done earlier and then started ProE. I than ran the ProE trail file, WOW it started to open parts, drawings and modify them as I did earlier. This worked great until it came to a stop or crash the trail file. I was unable to recover everything but I did get back about 3-4 hours of work.
This may be of use to someone else out there...
Tofflemire