Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

invalid handle index error on loading

Status
Not open for further replies.

rodney26

Aerospace
Joined
Feb 19, 2008
Messages
5
Location
GB
I am running NX4 and am having a problem with an important part (I need to print the drawings out today!)

Problem is as follows:-

-Part opened successfully this morning, continued working on draughting.

- NX crashed following a routine save so I closed everything and restarted the computer.

- On restarting the computer NX started up successfully

- The part I had been working on produced the following error on attempting to load it -

'An invlaid handle index was found reading an OM file: probable corruption'

- Further investigation shows that other parts from the same directory will load successfully and attempting to load the same part on a different machine results in the same error.

All help gratefully appreciated!

Roland
 
The best hope to get this particular part file fixed is to get it our GTAC organization so that development might have a chance to fix the part file. Otherwise, you will need to revert back to your last archived copy and start you last work session over.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

To an Engineer, the glass is twice as big as it needs to be.
 
Hi John,

Yes I have forwarded the part file to Teamcentre Engineering (our distributor) for them to have a look at it.

Thanks

Roland



 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top