Korichnevijgigant
Aerospace
- Oct 7, 2009
- 133
SO I came across a new error that I had not seen before (had to be on friday).
I created a model of a prototype, and when it worked I wanted to roll out a family table based on the prototype for different size parts.
The prototype was made with relations controlling hole patterns, but when I created the family table I deleted the relations since the family table would not be controlling the hole patterns.
BUT!
one of the deleted relations is still showing up when I check the family table instances.
It is displaying
Line 2 Section of model RE-750198-01::Invalid symbol 'sd17' found.
and the sd17 inside of the extrude does not even exist anymore, but its still showing up.
I checked in the section relations, in the top level, and the previous relation controlling sd17 is no longer there.
Any ideas?
Thanks
I created a model of a prototype, and when it worked I wanted to roll out a family table based on the prototype for different size parts.
The prototype was made with relations controlling hole patterns, but when I created the family table I deleted the relations since the family table would not be controlling the hole patterns.
BUT!
one of the deleted relations is still showing up when I check the family table instances.
It is displaying
Line 2 Section of model RE-750198-01::Invalid symbol 'sd17' found.
and the sd17 inside of the extrude does not even exist anymore, but its still showing up.
I checked in the section relations, in the top level, and the previous relation controlling sd17 is no longer there.
Any ideas?
Thanks