Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor 2009 and ANSYS Workbench 11.0

Thread starter ansysfreak
Start date Jul 1, 2008

Status: Not open for further replies.

Jul 1, 2008

ansysfreak

Civil/Environmental

Dear All

Are there Interface problems using Inventor 2009 and Workbench 11.0 sp1?
This is officially not supported by ANSYS but usely it still works. The 32-bit version of Inventor with 32-bit Workbench still works, but when Inventor becomes 64-bit the interface is killed.
Who is facing the same problem(s)?
Are there know workarounds?

Thanks
Garry