Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor 2010 iPart

Thread starter Superslinky
Start date Oct 28, 2010

Status: Not open for further replies.

Oct 28, 2010

Superslinky

Automotive

Hi all,

I think I already know the answer to this but thought I'd give it a shot. I've authored a feature on a part using iPart, its a resistor. One has long leads and the other has short leads. It is the EXACT same part and thats how I need it to show up idw parts list however it doesn't seem to work that way. If each resistor is configured differently based on the position of the leads I still need it be of the same quantity and part number. Is there a solution to this that I'm not aware of?

Thanks in advance!