Inventor LT Sheet Metal?

[yoshimitsuspeed]

I am confused about whether or not Inventor LT has any sheet metal or part flatten capability. In most the documentation they don't say anything about it however in their knowledge base they have info listed directly under LT on using the sheet metal capabilities. I have downloaded the demo suite and cannot find any of these tools. Is this just info put into the wrong section in the knowledge base?

http://knowledge.autodesk.com/suppo...F89A8FD9-DA80-4191-8637-8AA82833A606-htm.html

 

[mcgyvr]

LT does not offer sheet metal tools

http://www.autodesk.com/products/inventor-lt-family/compare/compare-products