Inventor to SW, what version works now?

[MortenDK]

Hello Helpful Forum!
I've just got a new job. They have used Inventor for some years now, but it appears I'm more or less the only one to do mech. drawings here. As I'm used to SW, how far is readability from Inventor to SW progressed? I have so far only found this question and answers in files from 2007, but as some of the inventor files are very recent, I would like to know if it is still possible to perform without too much hassle.
Regards
Morten

Morten K. Thillemann

 

[Gupta65]

Morten, I can't confirm about the Inventor version but you can always convert your files in Inventor to iges, parasolid or any other similar format and then import in SW.

Deepak Gupta
SW2009 SP4.1
SW2007 SP5.0
MathCAD 14.0