bsvk
Mechanical
- Jul 28, 2003
- 10
Hello all,
Is there any function/method to extract the number of dimensions required to make a sketch fully constrained? I have been trying at various sites and could n't make it. I could frame a small formula and that will provide the same. but it hardly depends on modellers own practice and it can do only for single closed loop. (limiting by mirroring line, extra lines etc...). And so I could not use this as it is not so consistant for above reason.
Anybody could help me out on this issue....
With Warm Regards,
bsvk
Is there any function/method to extract the number of dimensions required to make a sketch fully constrained? I have been trying at various sites and could n't make it. I could frame a small formula and that will provide the same. but it hardly depends on modellers own practice and it can do only for single closed loop. (limiting by mirroring line, extra lines etc...). And so I could not use this as it is not so consistant for above reason.
Anybody could help me out on this issue....
With Warm Regards,
bsvk