Invisible parts 1

[bbylls]

I have an assembly that has all the parts on the same layer and all set to be "shown"
There are 3 parts that are invisible. I have checked their layers, properties, transparency, object display.
Any ideas as to what could be making them invisible?

 

[cowski]

Have you checked the refernce set? Perhaps it is set to empty, or the ref set used has no objects in it.

www.nxjournaling.com

 

[bbylls]

I checked that.
Thanks.

 

[mmauldin]

Make sure the layer they are on is visible in view (Format>Layer Visible in view). "Reset to Global" should show any layers not visible.

 

[cowski]

Also check the "show components in view" and see if any are listed there (Assemblies -> context control -> show components in view).

Hide components in view is usually used to hide them in a drawing view, but it can also be used in modeling views (though I'd advise against that).

www.nxjournaling.com

 

[bbylls]

Didn't know about "show components in view".
That was it.
Thanks.