Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Involute Spline on shaft and hub

Status
Not open for further replies.

cadmate

Mechanical
May 5, 2005
84
GB
Hello all, no matter what settings I try, I always fail to produce a spline in a hub bore using the connection generator. I can get the spline into the shaft, but not the hub. Is there tutorial for this, using inventor 2008 pro.

Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top