Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Involute spline

Status
Not open for further replies.
vaslava

vaslava

Automotive
Sep 29, 2004
2
I am wondering you use any diametral pitch (DP) value when designing a shaft and hub involute spline system based on the ANSI B92.1 - 1996 standard. If so, how do yo calculate the machining tolerance and permissible effective variation when using a DP value that is not defined in the standard.
 
Status
Not open for further replies.

Similar threads

1MarcoD
  • Locked
  • Question
ANSI B92.1 and B92.2 Involute Splines 1
Replies
2
Views
285
1MarcoD
1MarcoD
LennartR
  • Locked
  • Question
hard to find "standard" splines
Replies
1
Views
23
jerry1423
jerry1423
brakemeister
  • Locked
  • Question
Formed Sheet Metal Spline
Replies
0
Views
26
brakemeister
brakemeister
pardal
  • Locked
  • Question
INVOLUTE SPLINE HUB
Replies
4
Views
76
MaartenHvO
MaartenHvO

Part and Inventory Search

Sponsor

Back
Top Bottom