Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is it possible to mix elements with different order in ANSYS meshing?

Status
Not open for further replies.
assafwei

assafwei

Materials
Joined
Jul 20, 2008
Messages
89
Location
IL
Hi,

I was wondering if it is possible to create a conforming mesh with diferent order elements. meaning same part with two bodies in mechnical meshing, one part with HEX8 and the other with TET10 to form a conformal mesh.
I would like to know if there is a way to do so.

Thanks.
 
Status
Not open for further replies.

Similar threads

S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
Tegguy
  • Locked
  • Question Question
ANSYS: Beam Elements vs Joint Stiffness?
Replies
11
Views
2K
Tegguy
Tegguy

Part and Inventory Search

Sponsor

Back
Top