Hi everyone!
Is it possible to use the fill pattern to fill a specified area (say a circle) with a feature (say a cut), to create something similar to the picture linked here?
Thanks for your help!
-Leav
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is it possible to use a fill pattern to make these cuts in Solid Edge?
- Thread starter Leav
- Start date
- Status
Similar threads
- Locked
- Question