Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is it possible to

Status
Not open for further replies.
Slaen

Slaen

Automotive
Jan 23, 2005
128
Is it possible to build a part in V5 but erase the history so just the model is there. So no one knows how it was built?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Yes. Take your source part and copy the top level part body. Next open a new part and then 'Paste Special as Result' and you should be left with a dumb solid of the original part within the new parts Main Body. This will have no history - but you can still take measurements from this new part.
 
Upvote 0 Downvote
Great thank you very much
 
Upvote 0 Downvote
Slaen - if you are in version 15 or 16 and you have an assembly, go to Tools-->Generate CATPart from Product. This will take your assembly and build 1 part file with "dumb" solids.

Regards,
Derek
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CarlosR2022
  • Question
Is it possible to show and hide "Points" & "Wires" similar to the options se
Replies
1
Views
199
LWolf
LWolf
CarlosR2022
  • Locked
  • Question
Is it possible to change the PDF version to PDF1.6 using VBA 1
Replies
2
Views
51
CarlosR2022
CarlosR2022
c800
  • Locked
  • Question
Need the code to get access to the properties and isolate the parts and save it 1
Replies
3
Views
106
Little Cthulhu
Little Cthulhu
Raul Berame
  • Locked
  • Question
Hello All, Is it possible to revert 1
Replies
8
Views
112
MKEdits
MKEdits
Dialga1
  • Locked
  • Question
Is it possible changing position of compass
Replies
1
Views
56
TiagoFigueiredo
TiagoFigueiredo

Part and Inventory Search

Sponsor

Back
Top Bottom