Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Is it Recomended to provide Column

Status
Not open for further replies.
Replies continue below

Recommended for you

Sort by date Sort by votes
If there are no special requirements otherwise, the most economical roof will be used. For tanks over 40' diameter or so, that will be a column supported roof. That may vary depending on local material and labor costs and preferences.
 
Upvote 0 Downvote
Yes, ... always provide a Column Supported roof for any tank storing Bitumen ..... Also, always paint the tank brown ....

MJCronin
Sr. Process Engineer
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

skangal
  • Locked
  • Question
is it allowed to use two grade plates( A36 and A516gr70) for same bottom plate for tanks.
Replies
1
Views
2
JStephen
JStephen
Jugaado Engineer
  • Locked
  • Question
Shaft Average Life according to Codes/Standards
Replies
1
Views
3
Gr8blu
Gr8blu
Youcef40
  • Locked
  • Question
Using thickened sheet plates to patches shell plates courses. 2
Replies
7
Views
9
Dhurjati Sen
Dhurjati Sen
Tor_019
  • Locked
  • Question
What is the different between " Pipe except the end" and "Pipe End" in API 5L Ta
Replies
7
Views
10
Tor_019
Tor_019
Frank Zhang
  • Locked
  • Question
API 650 5.1.5.7 Shell-to-Bottom Fillet Welds, annular plate more than 13does code allow fillet only 2
Replies
7
Views
8
IFRs
IFRs
Back
Top