Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is SA 240 TP347 right? 2

Status
Not open for further replies.
etsen

etsen

Mechanical
Joined
Sep 11, 2006
Messages
67
Location
CN
SA 240 TP 347 is used in internal cone of a heat exchanger. I think SA240 TP347 is wrong, because I can not find SA240 TP347 in the ASME BPVC SEC II - PART A. But I am not sure whether it is right. Could anybody explain that? Thanks a lot.
 
Sort by date Sort by votes
It's there - keep looking.
 
Upvote 0 Downvote
SA-240 is a plate specification. Drop the term "TP" on the grade designation. "TP" applies to tubular products (tubes & pipes)
 
Upvote 0 Downvote
People confuse Type with "TP" thinking that it is an abbreviation of Type. SA 240 Type 347 is there.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

yurachv
  • Question Question
Plate marking as per SA-480
Replies
11
Views
13K
yurachv
yurachv
MichaelDexter
  • Question Question
Mat SA-266 gr 2 EN equivalent
Replies
3
Views
10K
MichaelDexter
MichaelDexter
FPPE
  • Locked
  • Question Question
Applicability of SA-788 S12 for SA-182 F316 HUBBED TUBESHEET
Replies
0
Views
1K
FPPE
FPPE
KD007
  • Question Question
SA-193 Gr.B7M bolt material used in Wet H2S service is not passing requirement of UG44b clause.
2
Replies
20
Views
10K
r6155
r6155
FPPE
  • Locked
  • Question Question
SA-182 VS SA-965 for heat exchanger tubesheets and girth flanges
Replies
14
Views
7K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top