Turtlestacker
Computer
Hi all,
I recently left a large aerospace company where I developed some fairly deep skills with the NXOpen API over the course of the last eight years. We built component design systems which created fully defined geometry from code without any manual intervention. My question to you folks is - do you believe there is a market for an NXOpen based software business if I were to set one up? There seem to be a few players in the market place but was wondering if anyone believed there was room for one more - starting as a solo venture at the 'mom & pop' end of the market? I have some ideas which should set me aside from competitors but there is little point proceeding if the market is not there right? Thoughts welcome!
Cheers
Turtlestacker (Paul)
I recently left a large aerospace company where I developed some fairly deep skills with the NXOpen API over the course of the last eight years. We built component design systems which created fully defined geometry from code without any manual intervention. My question to you folks is - do you believe there is a market for an NXOpen based software business if I were to set one up? There seem to be a few players in the market place but was wondering if anyone believed there was room for one more - starting as a solo venture at the 'mom & pop' end of the market? I have some ideas which should set me aside from competitors but there is little point proceeding if the market is not there right? Thoughts welcome!
Cheers
Turtlestacker (Paul)
