Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is there a quick way to transform classic toolbar to ribbon without reconstructing

Status
Not open for further replies.

NXsupport

Computer
Apr 11, 2008
251
Hi,

Using NX12. I was wondering if there was a quick way to transform classic toolbar to ribbon toolbar without having to reconstruct it.
 
Replies continue below

Recommended for you

Have a look at below webpage. It has some clear tips on how to this. There are no changes compared to the NX9 way of working (to my best knowledge)
[URL unfurl="true"]https://zachimusprime.wordpress.com/2014/08/30/nx9-custom-ribbon-creation-for-noobs/[/url]
The document described in there I have attached for you.




Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor