is there a sketch inspector in NX

[NXsupport]

NX6.0.5.3

I was curious to know if there is a sketch inspector which can be run to make sure there are no overlapping or discontinuous curves.. Many times when constraining gets more tighter , there is a possibility of curves crisscrossing each other or may be a overlapping or dis jointed.

It would be good to have a sketch inspector to run and make highlight any such conditions and suggest options to correct the same.

 

[Toost]

I think that there more or less is one, hidden in the CheckMate. One has to select/assemble the tests you want to use/ run. I.e the overlapping objects test is a general test which applies to all curves. Don't know all the details. Maybe JCBCAD knows more.

Regards,
Tomas