Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is there a way to count the number of hinges that have gone plastic after TH analysis in sap2000.

Status
Not open for further replies.
Status
Not open for further replies.

Similar threads

juandavidguzman
  • Locked
  • Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
42
STpipe
STpipe
thomascook84
  • Locked
  • Question
SAP2000: Is it necessary to break an element at frame intersections? 2
Replies
2
Views
43
JoeH78
JoeH78
g.alshamsi
  • Locked
  • Question
Defining Plastic Hinges in built-up cold formed steel sections.
Replies
9
Views
34
driftLimiter
driftLimiter
hadsyogs
  • Question
Error 9 on SAP2000 "subscript out of range" ,help 1
Replies
2
Views
54
hadsyogs
hadsyogs
Luceid
  • Locked
  • Question
SAP2000 Interactive Database Bug
Replies
0
Views
41
Luceid
Luceid
Back
Top