Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISO 10993 compliant EPDM

Thread starter loughnane
Start date Mar 4, 2010

Status: Not open for further replies.

Mar 4, 2010

loughnane

Mechanical

I actually posted this in the materials engineer section, but then thought this might be a better venue. (Sorry moderators!)

I'm looking for an ISO 10993 compliant EPDM. I'll be compression molding it and don't want to use silicone because of it's poor tear strength.

Any thoughts?

Chris Loughnane - Product Design

http://www.pdnotebook.com

http://www.twitter.com/DesignNotebook