Issue after installing NX8 update

[DanKidman]

Hi everyone,

I'm having a strange issue after installing the update for NX8. When I start the program it comes up with a 'No disk' error, if I put the disk in the drive or cancel (sometimes have to do this several times) it starts.

Any ideas much appreciated.

 

[JohnRBaker]

This sounds like something that GTAC might be better equipped to deal with.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.