Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Item Revision (part family) gets changed automatically in NX integrated Teamcenter

Thread starter kkssandeep
Start date Oct 29, 2014

Status: Not open for further replies.

Oct 29, 2014

kkssandeep

Mechanical

We are using NX 8.5 integrated with Teamcenter 9.1.

While uploading the part family members for the first time to Teamcenter they are being uploaded properly without any change in item revision.

But when some of the part family members are updated and uploaded to Teamcenter again, the Item revision is getting changed to next revision.

Please provide any solution to overcome this issue.

Thanks in advance
Sandeep