Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

JIS to ASTM conversions?

Status
Not open for further replies.

Guest
Do conversions exist for the conversion of JIS to ASTM tensile bar results. I know that the JIS bar is larger but cannot cut to anything other than the ASTM, and a customer would like the results from the JIS bar.
 
Status
Not open for further replies.

Similar threads

BoHboH
  • Locked
  • Question
Risa3D to Risa Floor generated loads
Replies
0
Views
409
BoHboH
BoHboH
willrsawyer
  • Locked
  • Question
Application of CSA standards to imported end-user products
Replies
1
Views
472
Enable
Enable
Bubbrubb
  • Locked
  • Question
Converting a soccer-specific stadium to cricket
Replies
1
Views
471
Stick.
Stick.
QHHK
  • Locked
  • Question
Websites or tools for querying building loads
Replies
1
Views
440
Struct123ure
Struct123ure
Ron375
  • Locked
  • Question
Welding XM-19 & 316L together
Replies
2
Views
497
Ron375
Ron375

Part and Inventory Search

Sponsor

Back
Top Bottom