Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Joint Shear Design

Thread starter ENGJP22
Start date Oct 1, 2022

Status: Not open for further replies.

Oct 1, 2022

ENGJP22

Structural

Hi guys, I have this problem I'm trying to calculate the joint shear of a structure in ETABS 2019, but when I
assign the longitudinal reinforcement to the beam the program shows NC (Not Calculated) in almost every joint, if I
left the program to use the reinforcement required by analysis it shows the ratios for every joint.
Do you know what's happening?

Thanks in advanced