Journal question? 1

[shichen]

insert -> Curve -> Fit Spline -> point from File: insert all d1.dat, d2.dat, ..., d15.dat and end.dat and start.dat

insert ->
insert -> mesh surface -> through Curve Mesh ->
primary curves: curve from d1.dat and curve from d15.dat
cross curves: curve from end.dat and curve from start.dat

Question:
how I can do above use Journal, since I a lot of surface which have about 1000 lines?

Thanks for the help

 

[shichen]

all dat files attached

 

[FrankSwinks]

Attached is a journal (as .txt file which you need to change to .vb) which creates the splines from the dat files. I have written the code that it looks for the dat files in C:\temp\testdata. Please place your dat files in this dir. At this stage it only works for these particular named dat files.

I have not yes created the thru curve mesh surface.

Frank Swinkels

 

[FrankSwinks]

The attached file CurveMeshSurface.txt (change .txt to .vb) now also creates the the mesh surface.

Frank Swinkels

 

[shichen]

As a newbie of UG and VB this really helps. Thank you Frank.