JT Files Do Not Stay Constrained

[CBRent]

I am working in a new assembly using legacy parts and subassemblies. These parts were created in SDRC I-Deas.

When I bring the JT subassemblies into my new assembly the parts are positioned incorrectly. I've checked to be certain that the position of the parts isn't a remnant of an old config. It isn't. The incorrect position is not found in any of the SDRC assemblies when I open them in SDRC.

I have tried using different load options. So far, no joy.

Does this sound familiar to anyone?

Thank you,

Brent

 

[SDETERS]

What version of jt file you are using. You need to have a version nine jt file. To find out what version you have right click on jt file and open it in note pad. There us a system variable you will need to set to have your ideas to create version nine jt file
. I will add this tomorrow.

 

[SDETERS]

Please Look here for a discussion on this. I hope this is ok for this forum. But there is some good information about this at this link.

http://www.plmworld.org/p/fo/st/topic=23&post=9053#p9053