Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Knowledge fusion, when and how to use it???

Status
Not open for further replies.
IvanNX

IvanNX

Mechanical
Jun 9, 2005
267
0
0
SE
I read about KF, but I still do not understand what are situation, knowledge peaces, that can be "saved" and "reused" with this tool. Can somebody explain it a little?

_____________________________
Enjoy your work and have fun!
 
Status
Not open for further replies.

Similar threads

Franklin M.
  • Locked
  • Question
How hard is it to move from UG to Catia?
Replies
2
Views
25
CAD2015
CAD2015
Werner K
  • Locked
  • Question
Pull expression values into a component when adding to an assembly
Replies
5
Views
39
Werner K
Werner K
Dikuza
  • Locked
  • Question
NX: How to ignore touching pairs in Clearance Analysis and only review for hard interferences?
Replies
2
Views
16
cowski
cowski
hnam2003
  • Locked
  • Question
How to patch detail prints in NX 10
Replies
5
Views
46
Toost
Toost
mmauldin
  • Locked
  • Question
Can this be done in NX? And if so, how?
Replies
1
Views
19
AZPete
AZPete
Back
Top