Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

lamination material for high speed SR motor

Status
Not open for further replies.
mtrguy

mtrguy

Electrical
Sep 2, 2001
6
I am looking for a alternate to Aermet 100 for a high speed switched reluctance rotor. M19 lamination is too low in strength Aermet 100 stronger but sacrifices the magnetics.
Maybe there is something in between. Also Carpenter does not make Aermet in .014" thick sheets.

Anyone have ideas?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

freetown
  • Question
Uncoupled slip-ring induction motor speed
Replies
6
Views
2K
FacEngrPE
FacEngrPE
edison123
  • Question
KW rating of 4 pole motor at highest speed is low. 1
Replies
19
Views
6K
edison123
edison123
NickParker
  • Question
Location of AVR and speed/load sharing controller for Diesel generator sets
Replies
2
Views
2K
FreddyNurk
FreddyNurk
RM12
  • Question
H1 H2 H3 wires for space heaters (Induction motor) 1
Replies
6
Views
2K
edison123
edison123
K
  • Question
Motor Analysis
Replies
4
Views
1K
LionelHutz
LionelHutz

Part and Inventory Search

Sponsor

Back
Top Bottom