Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Land Desktop; 3d polylines

Status
Not open for further replies.

Rookie2

Civil/Environmental
Nov 15, 2003
75
Hi,

Is there a command that will automatically assign vertex elevations to a 3d polyline by reading them from a surface? I am thinking I either read about a way to do this or ran across the command at some point in the past; or is this just wishful thinking?

Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor