Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Largest denominator for patterns...

Thread starter closer9
Start date Mar 8, 2005

Status: Not open for further replies.

Mar 8, 2005

closer9

Mechanical

I'm having some trouble with Wildfire. In the config.pro I have the largest denominator set to 16, and all dimensions in fractions, yet whenever I create a pattern the denominator is always 3 regardless of what dimension I use. I've only noticed this on patterns...

Any ideas?

thanks...