Laser Bystronic BYstar 3015 4kW Overcurrent desk

[adna]

The laser works without any problems on 10-30%, but as soon as on 40% of the power it shuts down and it shows the Overcurrent Desk error??
Do you have any suggestions about what could be the problem?

 

[LaserEngine]

Maximum current on HV-rectifier card (stabilizer card)
 See acceptance report: laser gas flow rate indication
 See maintenance manual chapter “Laser”: vacuum test
 Otherwise call Bystronic customer service

These are the things suggested by an operator manual by Bystronic

 

[krugtech]

what is the current reading at 30%?


Chris Krug

http://krugtech.com/

Maximum Up-time, Minimum BS